Nippon Paint Singapore · Singapore
Aqua Primer Sealer Undercoat is listed by Nippon Paint Singapore (Singapore) under Primers, undercoats and sealers. Finish: Matt.
What it is for
Aqua Primer Sealer Undercoat is a water-based one step pre-coat formulated with special acrylic polymer for good adhesion on multi-purpose substrates
Specifications
| PaintColorKE category | Primers, undercoats and sealers |
|---|---|
| Manufacturer’s category | Water Based In the manufacturer’s own words |
| Finish | Matt |
| Basis | Not published |
| Coverage | Approx. 10-11 m 2 / litre depending on surface texture, substrate porosity and method of application As published, including its basis (per coat or for a system) |
| Coats | Not published |
| Touch dry | 30 minutes at 30°C |
| Hard dry | 2 hours at 30°C |
| Recoat | Minimum 2 hours under normal conditions |
| Cure | Not published |
| Application | Roller or brush |
| Thinning | Not published |
| Colours | Not published |
| Tintable | Not published |
Values are the manufacturer’s wording, with their units and conditions (temperature, number of coats). Touch dry, hard dry, recoat and cure are different stages. Check the current product data sheet before painting.
Pack sizes
- 1 Litre
- 5 Litre
As listed on the product page. Not every pack is available in every colour or market.
Surface preparation (as published)
New or unpainted interior and exterior masonry surfaces: a) Remove all imperfections and sand down for an even surface b) Remove dust, contaminants or foreign matter with damp cloth c) Allow surface to dry Previously painted interior and exterior masonry surfaces: a) Remove any loose, peeling or flaking paint using scrapper or water jet wash whichever is suitable b) Repair any imperfections. Fill cracks with suitable water-resistant putty or filler and sand down to an even surface c) Remove dust, contaminants or foreign matter with damp cloth d) Remove oil or grease by solvent cleaning or mild detergent. Allow surface to dry e) If fungus, moss or mould is visible, use Anti-Fungus Solution to treat the affected surface. Leave solution for at least 2 hours f) Ensure that the previously painted surface is sound g) If surface has a high gloss or semi-gloss finish, sand to remove the high gloss to enable the new paint to adhere New or unpainted dressed or raw exterior timber: a) Remove all imperfections and sand for a smooth surface b) Fill nail holes with a suitable, exterior grade water-resistant wood filler c) Remove dust and contaminants Metal surfaces: a) Thoroughly degrease and clean new metal surfaces (e.g. galvanized iron) to remove oil or other contaminants using suitable cleaning solvent b) Allow to dry For other metal surfaces which has rusted (e.g. mild steel), clean with abrasive cloth to remove rust. Do not use steel wool. Use suitable cleaning solvent to remove traces of impurities and contaminants before applying a coat of suitable primer. Under non-aggressive indoor conditions, the product can be used directly on clean metal surfaces. Otherwise, apply a coat of Crystalux A/C Primer on the well-prepared surfaces Plastic surfaces: a) Thoroughly degrease and clean new surfaces to remove oil or other contaminants using suitable cleaning agent. b) Light sanding is recommended to enhance adhesion.
Source
Official product page · checked October 25, 2026
Product information is the manufacturer’s, read from the official page on that date. PaintColorKE does not sell paint and does not rank products.
Screens and lighting change how colour looks. Confirm a physical sample and the actual product specification before buying paint.